User's Manual

6
4. Plug the telephone’s foot-long CAT 5 line cord into the primary Ethernet line interface jack
(identified by an icon that looks like a modular wall jack).
5. Place the other end of the line cord through the round hole in the middle of the stand, and
snake it out through the rectangular opening in the center of the stand.
6. If a connection to the Ethernet hub and secondary interface jack is required, plug the 14-foot
CAT 5 line cord into the adjacent jack (identified by an icon on the right that looks like a stylized
PC). Temporarily drape the cord over the front of the telephone.
7. Plug the line cord into the wall jack.
8. Place the 4606 IP telephone against the wall so that the studs on the mounting plate enter the
keyholes in the stand. Then pull the telephone down so that the studs slide into the cutout
channels.
9. If the Ethernet hub line cord (step 6 above) is used, route it along the left side of the stand
against the wall to keep it out of the way.
LINE
ADJ
LINE
ADJ
a
b