User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
AT Command Set
A-30
Command: &Y
Function: Designate the default configuration profile.
Type: configuration
Arguments: An argument of 0 will recall stored profile 0; an
argument of 1 will recall stored profile 1. Factory-default
selection is stored profile 0.
S-Register: none
Example: AT&Y1
Comments: In the example, the configuration profile stored in
location 1 will be recalled the next time that the 8400B
Plus Data Module is powered on. When the &Y
command is issued, the currently active profile does
not
change until the 8400B Plus Data Module is powered
off and then on again.
See Also: "Configuration Parameters" on page 3-7 and the &V
command on page A-28
.
Table A-1. Accepted AT Command Labels
Label Description
ENTER
020709_2.book Page 30 Friday, April 23, 1999 5:39 AM