User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
Dial Modifiers
B-4
Dial Modifier: S=
n
Function: Dial the number stored in location
n
, where
n
has a
value 0-3.
S-Register: none
Example: ATDS=0
Comments: The S=
n
dial modifier allows the 8400B Plus Data
Module to dial a number previously stored with the &Zn
command. In the above example, the number stored in
location 0 is dialed. The S=
n
dial modifier can also be
used for voice calls.
See Also: "Voice Operations" on page 3-18 and the &Z command
on page A-31.
Table B-1. Dial Modifiers
Label Description
ENTER
020709_2.book Page 4 Friday, April 23, 1999 5:39 AM