User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
S-Registers
C-14
Register: S7
Description: Wait time for connection to remove endpoint. If the data
mode is not entered within this time, the call will be
disconnected.
Range of Values: Value may be 001 through 255 seconds; factory-default
value is 060 seconds.
Storable: yes
Comments: Even though S7 is storable, it is not displayed with the
stored profile data generated by the AT&V command.
See Also: "Dialing a Data Call" on page 3-10.
Table C-1. Labels Used in S-Registers
Label Description
020709_2.book Page 14 Friday, April 23, 1999 5:39 AM