User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
Quick-Reference Summaries
E-7
Table E-4. Result Codes
Verbose Form Numeric Description
OK
0 Command accepted.
CONNECTED
1 Connection made at 300 bps.
NOTE:
If command X0 is in effect,
CONNECTED
means connection
made at whatever speed both ends
of the call agreed upon.
RING
2 Ring signal detected.
NO CARRIER
3 Carrier signal not detected or lost.
ERROR
4 Error in command line.
CONNECT 1200
5 Connection made at 1200 bps.
BUSY
7 Busy signal detected.
CONNECT 2400
10 Connection made at 2400 bps.
CONNECT 4800
11 Connection made at 4800 bps.
CONNECT 9600
12 Connection made at 9600 bps.
CONNECT 19200
14 Connection made at 19200 bps.
020709_2.book Page 7 Friday, April 23, 1999 5:39 AM