User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
Installation
2-13
Installation Options
line is administered. Check with your telecommunications manager to
administer the line for simultaneous voice and data or data service
required.
US Companding
This option is set, by default, for
Yes
. Leaving this default permits the 8400B
Plus Data Module to digitize voice signals according to the Mu-Law standards
commonly used within the United States.
Setting this option to
No
requires the 8400B Plus Data Module to digitize voice
signals according to the A-Law standards commonly used outside of the United
States.
NOTE:
A change in the setting of this option becomes effective immediately.
Telephone Provides Dialing
This option is set, by default, for
Yes
. Leaving this default permits the 8400B
Plus Data Module to use the telephone’s DTMF dialing circuits to perform the
dialing function. This setting also permits the telephone to annunciate the
touch-tones.
Setting this option to
No
requires the 8400B Plus Data Module to perform the
dialing function using its internal DTMF dialing circuit. The
No
setting does not
allow touch-tones to be annunciated.
NOTE:
A change in the setting of this option becomes effective immediately.
020709_2.book Page 13 Friday, April 23, 1999 5:39 AM