User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
AT Command Set
A-15
Command: Q
Function: Turn the display of result codes on or off.
Type: configuration
Arguments: No argument or an argument of 0 enables the display of
result codes; an argument of 1 disables the display of
result codes. The factory-default is result codes enable.
S-Register: Bit 2 of S14 is set according to the argument used with
the Q command.
Example: ATQ1
Comments: In the example, the result codes are disabled. Use this
option only if you wish to prevent the 8400B Plus Data
Module from returning result codes after an AT
command is issued.
See Also: The V command on page A-18
, the X command on
page A-19
, S-register S14 on page C-20, and the result
codes on page E-7
.
Table A-1. Accepted AT Command Labels
Label Description
ENTER
020709_2.book Page 15 Friday, April 23, 1999 5:39 AM