User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
AT Command Set
A-21
Command: Z
Function: Reset the 8400B Plus Data Module and recall a stored
profile.
Type: immediate
Arguments: No argument or an argument of 0 recalls the
configuration profile stored in location 0; an argument of
1 recalls the configuration profile stored in location 1.
S-Register: none
Example: ATZ1
Comments: In the example, the Z command causes the 8400B Plus
Data Module to reset, and then loads the configuration
profile stored in location 1 into the active location.
See Also: "Configuration Parameters" on page 3-7.
Table A-1. Accepted AT Command Labels
Label Description
ENTER
020709_2.book Page 21 Friday, April 23, 1999 5:39 AM