User's Guide
Table Of Contents
- Table of Contents
- About This Document
- 1. Introduction
- 2. Installation
- 3. Configuration and Operation
- 4. Troubleshooting
- A. AT Command Set
- B. Dial Modifiers
- C. S-Registers
- D. Isolating Problems Using Loopback Data Tests
- E. Quick-Reference Summaries
- Glossary
- Index
8400B Plus Data Module User’s Guide
555-020-709
Issue 2
November 1996
AT Command Set
A-24
Command: &F
Function: Load the factory-default configuration.
Type: immediate
Arguments: none
S-Register: none
Example: AT&F
Comments: The factory-default configuration values are
permanently stored in ROM and can be recalled at any
time. No reset or self-test is initiated by issuing the &F
command. The &F command does not recall the
factory-default installation options established by the
value of S-register S24.
See Also: “Configuration Parameters” on page 3-7.
Table A-1. Accepted AT Command Labels
Label Description
ENTER
020709_2.book Page 24 Friday, April 23, 1999 5:39 AM