Configuration manual

Chapter 5 Configuring the APPP features 19
Advanced Paging Prductivity Pack Configuration
Variable definitions
Configuring features
Configure up to 50 feature codes on your BCM system to send a programmed text message to a
specific telephone directory number (DN). Each feature code is associated with a different text
message. Access each feature by pressing the appropriate key on your telephone dialpad.
Program the feature codes on the Auto-Attendant Properties page in CallPilot Manager
(CallPilot Manager > Auto-Attendant > General Properties page).
For more information about the variables on the One Button Text panel (Feature Configuration
tab), see the table One Button Text panel—Global Settings tab (page 19).
Procedure steps
Step Action
1 From the Element Manager navigation panel, select
Configuration > Applications > Advanced Paging Productivity
Pack > One Button Text.
2 From the One Button Text panel, select the Feature Configuration tab.
3 Click Add.
4 From the Add Feature Code box, type the feature code in the Feature Code
field.
5 Click OK.
6 From the Feature Configuration tab, select the feature code to modify.
7 In the Details for Feature Code panel, type a text message in the Text
Message field.
8 Type the number of the destination DN in the Destination DN field.
9 To add more feature codes and associated text messages, repeat
steps 3 to 8.
Table 1 One Button Text panel—Global Settings tab
Variable Value Description
Alert Tone Enable or Disable A toggle to enable or disable an alert tone that
signals to the user that a message is received.
The alert tone is always enabled on the following IP
Phones (you cannot disable this variable): IP Phone
2004 (phase 1 and phase 2), IP Phone 2006,
IP Phone 2007, IP Phone 1140E, IP Phone 2050,
and WLAN Handsets 2210/2211/2212.
Display Timeout(s) 60–300 seconds The amount of time for the recipient to respond to
the message. When the time expires, a no response
message is returned to the sender, indicating that
the message was not received.