User's Manual

Installing ARE Memory Upgrade Modules
112831-D Rev. A
9
4.
Gently push down on the module so that the retainers grasp the SIMM,
locking it into place (Figure 6)
.
When the SIMM is properly inserted, the two small vertical black poles on the
SIMM socket line up with the two holes in the SIMM.
Figure 6. Locking a SIMM in Place
5.
Repeat steps 2 through 4 to install the other SIMM in socket U14.
6.
Install the ARE processor module in the router.
Refer to Installing and Maintaining BN Routers for instructions on replacing a
FRE/FRE-2 module.
Attaching the Upgrade Label
The upgrade kit comes with a label, either 32 MB Upgrade or 64 MB Upgrade. To
apply the label:
1.
Remove the paper backing from the label.
2.
Place the label on the right ejector lever (Figure 7).
Black poles on
socket must
line up with
holes in SIMM
Retainer
A320009A