User's Manual

Administering settings at the phone
Implementing Avaya B189 Conference IP Phone describes how to use Administration Menu
procedures at the phone for administration. The local procedures you might use as an
administrator are:
• 802.1x - Enable or disable the Supplicant and the Pass-thru options.
• ADDR - Add the IP addresses for the call server, HTTP server, HTTPS server, and other
network related parameters.
• CLEAR - Remove all administered values, user-specified data, option settings, etc. and
return a phone to the phone's initial “out of the box” default values.
• DEBUG - Enable or disable debug mode for the button module serial port.
• GROUP - Set the group identifier on a per-phone basis.
• INT - Set or change the interface control value(s) of PHY1STAT
• RESET VALUES - Reset the phone to default values including any values administered
through local procedures, and the values that were previously downloaded using DHCP
or a settings file.
• RESTART PHONE- Restart the phone in response to an error condition, including the
option to reset parameter values.
• SSON - To add site specific options.
• Test - To run a self test on the phone.
• VIEW - Review the Avaya B189 Conference IP Phone system parameters to verify the
current parameter values and file versions.
Note:
You can use the DEBUG option only if you change the default password to the Administration
Menu procedures through the PROCPSWD parameter.
The new value of the PROCPSWD parameter must be 4 to 7 numeric digits, "0000" through
"9999999". However, if value of PROCPSWD is less than 4 digits, the value will be changed
back to the default value of 27238.
Administering display language options
By default, Avaya B189 Conference IP Phones display information in the English language.
All software downloads include language files for 13 more languages. Administrators can
Administering Deskphone Options
70 Administering Avaya B189 Conference IP Phone December 2013
Comments? [e-mail]