User's Manual

Issue 5.0 May 2005 91
System printer and Report Scheduler
The Report Scheduler is enabled on the System-Parameters Features screen. Only an
authorized representative can access and make changes to the System-Parameters
Customer-Options screen. The parameters of the system printer, which are used by the
Report Scheduler feature, are administered on the Feature-Related System Parameters
screen. If the parameters for the system printer are not administered, scheduled reports
cannot be printed. The system administrator may access this screen by entering the
change system-parameters features command. This command and the
requirements for using the Feature-Related System Parameters screen to set up the
Report Scheduler are covered in this section.
This section includes the following topics:
● System printer on page 91
● Report Scheduler on page 94
System printer
The system printer, rather than the printer that is attached directly to the management
terminal, is used to print scheduled reports. Scheduled reports cannot be sent to the
management terminal or to its printer.
Note:
Note: The system printer should not be confused with and does not replace the
printers dedicated to journal, Call Detail Records (CDR), or Property
Management System (PMS). The Report Scheduler is intended to print all
system reports and the output of virtually all list, display, and test
commands.
This section includes the following topics:
● System printer administration on page 92
● System printer data link operation and maintenance on page 93