User's Manual
Table Of Contents
- Using the Bay Command Console (BCC)
- Contents
- Figures
- Tables
- Preface
- Chapter1 Overview of the BCC
- Chapter2 Getting Started with the BCC
- Entering and Exiting the BCC Interface
- Displaying Your Location in Configuration Mode
- Navigating in Configuration Mode
- Displaying Configuration Data
- Displaying Help on System Commands
- Displaying Help on show Commands
- Chapter3 Entering Commands and Using Command Files
- Chapter4 Tutorial: Configuring a Bay Networks Router
- AppendixA Multilevel Access
- AppendixB System Commands
- AppendixC TCL Support
- Appendix D System show Commands
- AppendixE Syntax for Module Location
- Appendix F BN Console Slot Election
- Index
Using the Bay Command Console (BCC)
2-4
117383-D Rev 00
Navigating with the back Command
In BCC configuration mode, use the
back
command to move a specific number of
levels back toward root level. The syntax for the
back
command is as follows:
back
[
<n>
]
n
is the number of levels.
Entering the
back
command with no argument moves you back one level closer to
root level.
Example:
rip/192.168.125.34#
back
ip/192.168.125.34/255.255.255.224#
back
ethernet/2/1#
Entering the
back
command with an integer moves you from your current
working location, back toward root, the number of levels you specify.
Example:
rip/192.168.125.34#
back 2
ethernet/2/1#
In this example, the
back 2
command moves you from the current working
location (rip/192.168.125.34), back two levels to ethernet/2/1 (with
ip/192.168.125.34/255.255.255.224 as the intervening level).
Note:
If you enter an integer value that exceeds the actual number of levels
back to root (box or stack) level, the BCC returns to root level.