User's Manual
Table Of Contents
- Using the Bay Command Console (BCC)
- Contents
- Figures
- Tables
- Preface
- Chapter1 Overview of the BCC
- Chapter2 Getting Started with the BCC
- Entering and Exiting the BCC Interface
- Displaying Your Location in Configuration Mode
- Navigating in Configuration Mode
- Displaying Configuration Data
- Displaying Help on System Commands
- Displaying Help on show Commands
- Chapter3 Entering Commands and Using Command Files
- Chapter4 Tutorial: Configuring a Bay Networks Router
- AppendixA Multilevel Access
- AppendixB System Commands
- AppendixC TCL Support
- Appendix D System show Commands
- AppendixE Syntax for Module Location
- Appendix F BN Console Slot Election
- Index
Getting Started with the BCC
117383-D Rev 00
2-5
Navigating with Configuration Commands
Using BCC configuration commands, you can:
• Move back to a previous level.
• Move back to root level.
• Move forward to the next level.
• Move from your current level to any other level in the device configuration
tree.
Moving Back One or More Levels
To move from your current working level back one or more levels closer to root
level of the device configuration tree, you can enter the full BCC instance ID of
the desired object, as follows:
Example (go back one level):
rip/192.168.125.34#
ip/192.168.125.34/255.255.255.224
ip/192.168.125.34/255.255.255.224#
Example (go back two levels):
rip/192.168.155.151#
ethernet/2/1
ethernet/2/1#
In the second example, the BCC searches back toward root until it finds a context
or level where the object you specified (in this case, ethernet/2/1) exists in the
router configuration tree. The BCC enters the context of this object, and the
prompt displays your new location.
Moving Back to Root Level
You can move back to root level in configuration mode by entering the name of
the object at that level.
For an AN, ANH, ARN, or BN router, enter:
ip/1.2.3.4#
box
box#
For an ASN or System 5000 router, enter:
ip/1.2.3.4#
stack
stack#