User's Manual
Table Of Contents
- Using the Bay Command Console (BCC)
- Contents
- Figures
- Tables
- Preface
- Chapter1 Overview of the BCC
- Chapter2 Getting Started with the BCC
- Entering and Exiting the BCC Interface
- Displaying Your Location in Configuration Mode
- Navigating in Configuration Mode
- Displaying Configuration Data
- Displaying Help on System Commands
- Displaying Help on show Commands
- Chapter3 Entering Commands and Using Command Files
- Chapter4 Tutorial: Configuring a Bay Networks Router
- AppendixA Multilevel Access
- AppendixB System Commands
- AppendixC TCL Support
- Appendix D System show Commands
- AppendixE Syntax for Module Location
- Appendix F BN Console Slot Election
- Index
Getting Started with the BCC
117383-D Rev 00
2-19
show config
[
<BCC_instance_ID>
] -recursive -verbose
or:
show config [
<BCC_instance_ID>
] -r -v
Example:
Display parameters of an object configured at the next subcontext level, relative to
your current location in the device configuration tree.
box# eth 2/1 (first navigate to the object)
ethernet/2/1# show config -r -v
ethernet slot 2 connector 1
circuit-name E21-alpha
state enabled
bofl enable
bofl-timeout 5
hardware-filter disable
transmit-queue-length 0
receive-queue-length 0
bofl-retries 5
bofl-tmo-divisor 1
ip address 192.168.125.34 mask 255.255.255.224
state enabled
assocaddr 0.0.0.0
cost 1
broadcast 192.168.125.32
. . .
. . .
. . .
. . .
back
rip
state enabled
supply enabled
listen enabled
. . .
. . .
. . .
back
back
back