User's Manual
Table Of Contents
- Using the Bay Command Console (BCC)
- Contents
- Figures
- Tables
- Preface
- Chapter1 Overview of the BCC
- Chapter2 Getting Started with the BCC
- Entering and Exiting the BCC Interface
- Displaying Your Location in Configuration Mode
- Navigating in Configuration Mode
- Displaying Configuration Data
- Displaying Help on System Commands
- Displaying Help on show Commands
- Chapter3 Entering Commands and Using Command Files
- Chapter4 Tutorial: Configuring a Bay Networks Router
- AppendixA Multilevel Access
- AppendixB System Commands
- AppendixC TCL Support
- Appendix D System show Commands
- AppendixE Syntax for Module Location
- Appendix F BN Console Slot Election
- Index
Entering Commands and Using Command Files
117383-D Rev 00
3-5
System Commands
The BCC supports all system commands described in Appendix B. For help on a
specific command, enter:
help
<command>
Example:
help pwc
Configuration Command Syntax
This section describes BCC configuration commands and the syntax requirements
for those commands. This section also describes how to enter BCC configuration
commands using the following formats:
• Basic (full) syntax
• Default syntax
• Abbreviated syntax
Note:
If you inadvertently type one of the opening symbols and see an
underscore (
_) prompt, just type the corresponding closing symbol to restore
the normal (#) prompt in BCC configuration mode.
Caution:
Configuration commands make real-time changes to the device
configuration.