User's Manual
Table Of Contents
- Using the Bay Command Console (BCC)
- Contents
- Figures
- Tables
- Preface
- Chapter1 Overview of the BCC
- Chapter2 Getting Started with the BCC
- Entering and Exiting the BCC Interface
- Displaying Your Location in Configuration Mode
- Navigating in Configuration Mode
- Displaying Configuration Data
- Displaying Help on System Commands
- Displaying Help on show Commands
- Chapter3 Entering Commands and Using Command Files
- Chapter4 Tutorial: Configuring a Bay Networks Router
- AppendixA Multilevel Access
- AppendixB System Commands
- AppendixC TCL Support
- Appendix D System show Commands
- AppendixE Syntax for Module Location
- Appendix F BN Console Slot Election
- Index
Using the Bay Command Console (BCC)
4-14
117383-D Rev 00
30.
Check values currently assigned to parameters of FTP.
ftp# info
on box
state enabled
default-volume 2
login-retries 3
idle-timeout 900
max-sessions 3
tcp-window-size 60000
31.
Change the default volume number to 5.
ftp# def 5
ftp#
32.
Verify the change to the default volume number.
ftp# def
default-volume 5
33.
Recheck the total device configuration.
ftp# show config -all
box type frecn
board slot 5
type sync
back
board slot 7
type srml
back
board slot 9
type dtok
back
board slot 11
type wffddi2m
back
board slot 13
type qenf
back
console portnum 1
prompt {"%slot%:"}
auto-manager-script automgr.bat
auto-user-script autouser.bat
back
ethernet slot 13 connector 1
circuit-name E131
ip address 192.168.133.114 mask 255.255.255.224
. . .
. . .
(remaining configuration not shown here)