User's Manual

BCM450 System Start Up
22 NN40010-317 Issue 1.2 BCM450 Rls 6.0
6. If you prompted to reboot the BCM after entering the keycode file
select the Administration tab followed by Utilities, Reboot and then
click the Reboot button.
Note: The feature status change in the keycodes panel may take up to one
minute to display depending on the system load and component response.
You can refresh the keycode window to see the feature status change, after
adding the keycode file, by selecting the refresh button in Element Manager.
Some keycodes require the BCM to be rebooted.
Configuring the LAN IP Address
If the IP Address of the BCM system requires changing, i.e. to suit the
customer’s network, use the following procedure.
Both LAN ports will use this IP Address, unless VLANs are to be configured
(refer to the VLANs Guide for more information). The LAN IP Address does
not apply to the OAM port.
1. Access Element Manager (refer to Element Manager Connection to
the BCM section of this guide).