User's Manual

BCM450 System Start Up
NN40010-317 Issue 1.2 BCM450 Rls 6.0 49
6. The Configure dialog box will appear. You can accept the defaults or
configure new extension (station) or line (trunk) information:
 Station Module: Accept the defaults or configure the Start DN,
Public received digits/OLI, and Private received digits/OLI. The
received digits and OLI information will be assigned sequentially to
the number of stations available on that module. There is also the
option of assigning Target Lines to the extensions on the MBM. Tick
the Assign target lines check box to do this.
 Trunk Module: Accept the default Start Line number or enter a new
starting line number for the trunks presented on the MBM.
Note: There must be enough DN’s available in the system to populate the
entire MBM being configured, otherwise you will not be able to configure the
MBM and it will not function.
Note: There must be enough consecutive line numbers available in the
system to populate the entire MBM being configured, otherwise you will not be
able to configure the MBM and it will not function.
Note: Received Digits and OLI settings can be configured in other areas of
Element Manager, such as Telephony, Active Sets. However, configuring
these settings in Telephony Resources is a convenient and time saving
method, if feasible on your installation.
7. Click on OK when you have entered the required settings.
8. If you are not using the BCM expansion unit in the installation, skip to
step 12 in this section.