User's Manual

BCM450 System Start Up
NN40010-317 Issue 1.2 BCM450 Rls 6.0 51
12. You will notice that the required Dip Switch configuration for each
MBM is defined in the Dip Switch column. Note this down for when dip
switch configuration on the MBM is required later in the procedure.
13. Also, the full range of extensions or lines for each MBM are listed in the
Low and High columns. This may also be worth noting for reference
purposes.
14. The BCM should now be shut down to allow MBM dip switch
configuration and installation.
Note: Do not install MBM’s whilst the BCM is powered up.
15. Switch to the Administration tab, and navigate to Utilities, Reboot.
Click on Shutdown System
16. Click on the Shutdown System button.