User's Manual

BCM450 System Start Up
52 NN40010-317 Issue 1.2 BCM450 Rls 6.0
17. Click OK to shutdown the BCM.
18. An advisory dialog box will display. Click OK to close the box.
19. When the BCM is fully powered down, i.e. the status and power LED’s
are unlit, it will be safe to install the MBM’s. Dip switches should be
configured before installing the MBM’s. Refer to the Configuring the
MBM Dip Switches & Powering up the BCM section of the Media
Bay Modules guide.
Note: For information on configuring the FEM module, refer to the
Configuring the Fibre Expansion Module section of this guide.
Media Bay Module Specific Settings
It may be necessary to change specific settings on each module, e.g.
protocols or clock source for example. The following sections describe how to
configure detailed settings on each Media Bay Module.
Use the following procedure to configure the MBM specific settings.
1. Launch Element Manager and connect to your BCM.
2. In the Configuration tab, open the Resources folder and click on
Telephony Resources.