User's Manual
BCM450 System Start Up
8 NN40010-317 Issue 1.2 BCM450 Rls 6.0
Flow Chart
The flow chart outlines the steps involved in System Start-Up:
Configure a PC to connect to
the BCM: refer to the PC
Configuration section of this
guide.
Enter Keycodes to unlock
features/functionality: refer to
the Software Keycodes
section of this guide.
Ensure IP Sets, IP Trunks, and
Media Bay Modules have correct
DN/line numbers and are
enabled: refer to the Telephony
Resources Configuration
section of this guide.
Obtain the Keycode file: refer to
the Obtaining a Keycode file
section of this guide.
Install Element Manager &
Connect to the BCM: refer to
the Installing the Element
Manager Application section
of this guide.
Configure the BCM IP Address:
refer to the Configuring the
LAN IP Address section of this
guide.
Set the DHCP mode (standard
BCM only): refer to the
Configuring DHCP section of
this guide.
Set the name of the BCM: refer
to the Setting the System
Name section of this guide.
Ensure the date & Time is
correct: refer to the Setting the
Date & Time section of this
guide.
Configure Telephony Region &
Start DN: refer to the Setting
the Start DN & Telephony
Region section of this guide.
Initialise CallPilot Manager:
refer to the Initialising
CallPilot Manager section of
this guide.
If the BCM is to be connected to the network,
refer to the Connecting the BCM to the
Network section of this guide.
Obtain the required information
from the network administrator
etc: refer to the Required
Information section of this guide.
Set the Received Number
lengths: refer to the
Configuring the Received
Number Lengths section of
this guide.
Install Media Bay Modules:
refer to the Installing the
Media Bay Modules section of
the Media Bay Modules guide.