Installation Guide

Installing and Removing BCMS Vu Software
4-26 Installing BCMS Vu Wallboard Software
Installing BCMS Vu Wallboard Software 4
To start the BCMS Vu Wallboard software installation setup program, complete the
following steps:
1. Close all running programs on this PC.
2. Load the BCMS Vu software distribution CD-ROM into the drive.
Note
Installing Wallboard software is not the same as registering (also
called “Configuring”) a wallboard. Wallboard software permits a
user to send a report or message to a wallboard. Registering a
wallboard involves telling BCMS Vu Server the location and
specifications of wallboards connected to PCs on the network.
Note
It is not necessary to install the wallboard software on the same PC
as BCMS Vu Server software; Server software includes Wallboard
software. However, you must install Wallboard software on every
other PC to which a wallboard that is registered with the Server is
physically connected.
Note
If you choose to install BCMS Vu Wallboard after you installed BCMS Vu
Client, and you did not re-boot your PC, but instead selected “Setup
BCMS Vu Wallboard” in the “BCMS Vu R2 Master Setup” window, go
to “Welcome” on page 4-28.