Installation Guide

Introduction
2-22 Configuring a Network
If TCP/IP is installed, a window appears describing the configuration. If
TCP/IP is not installed, you receive an error message. If you receive an
error message, go into Start/Settings/Control Panel/Network and add
TCP/IP Protocol. (You may need the Windows installation disk.)
❐ In the list of installed network components, highlight “Network
Adapter” and select Properties.
Driver Type: Enhanced mode [32 bit and 16 bit]
NDIS driver*
Bindings: TCP/IP*
Advanced: Maximum Transmit Value*
Not Present or No*
❐ (Windows 95 or Windows 98)
Primary Network Logon Client for Microsoft Networks**
❐ Configure Client for Microsoft Networks.
❐ Under “Logon Validation” leave the box unchecked and the
“Windows NT domain” field blank, unless this PC is part of
Windows NT domain.
❐ Do nothing to “Network logon options.”
❐ (Windows 95 or Windows 98) On the “Identification” tab
❐ You must supply the PC name. The BCMS Vu Server PC must be
accessible under that name to the BCMS Vu Client. If you are
using DNS, this name must be the same as the DNS Host name.
Note
In a multi-protocol environment, if TCP/IP is not the
primary protocol in Windows 2000 or Windows NT 4.0 or is
not the default protocol in Windows 95 or Windows 98, then a
NetBIOS connection to the VUSHARE can happen through
another protocol. Therefore, be sure that TCP/IP is the
primary protocol.