Installation Guide

Introduction
Chapter 1
Configuring a Network 2-25
3. After you install and run BCMS Vu Server software, verify that the
BCMS Vu shared folder, “VuShare,” can be seen from all Clients.
If you are unsuccessful, ask your network administrator to perform the
configuration
Configuring a PC without a Network Interface Card
(NIC)
2
If your BCMS Vu Server satisfies the following requirements:
l Is in stand-alone mode (Server and Client software reside on the same PC)
l Does not have a NIC
Configure it using the following settings:
Note
Problems may arise if the Windows PC has previously had NIC
drivers installed even if the NIC has been removed.
For this reason, remove any previously installed NIC drivers. To
do this, in Start/Settings/Control Panel/Network/Adapters
highlight the NIC driver and select Remove.