User's Manual

Installation
10 Issue 1 November 1998
Counter-Mounted Installation
The list of parts needed and the steps for mounting the wallboard
on a counter are explained below. Unless otherwise stated, the
wallboard includes the parts mentioned.
Required Parts
■ Wallboard
■ Four (4) pivot brackets
■ Eight (8) #8-32 X .375 screws
■ Eight (8) #8-32 lockwashers
■ Two (2) 5/16" 18 X .50 screws
■ Two (2) 5/16" 18 hex nuts
■ Two (2) 5/16" split lockwashers
■ Two (2) cotter pins
■ Eight (8) rubber bumpers
Procedure
Follow these steps to mount the wallboard on a counter
(see Figure 2):
1. As necessary, remove power from the wallboard.
2. Place two rubber bumpers on each pivot bracket.
3. Mount two pivot brackets to the back of the wallboard’s
aluminum extrusion by using four
#8-32 X .375" screws and four #8-32 lockwashers. Place the
screws with the lockwashers into the #8-32 tapped holes on
the extrusion that line up with the holes in the pivot bracket.
4. Screw the other sides of the pivot brackets into the counter.