User's Manual

Installation
12 Issue 1 November 1998
Required Parts
■ Wallboard
■ Two (2) hanging brackets
■ Two (2) #6-32 X .50" panhead screws
■ Two (2) #6-32 lockwashers
■ Two (2) “S” hooks
■ Chain for suspending the wallboard (not supplied with the
wallboard)
Procedure
Follow these steps to suspend a wallboard from the ceiling
(see Figure 3):
1. As necessary, remove power from the wallboard.
2. Remove an end cap from the wallboard.
3. Slide the two hanging brackets into the channel on the top of
the wallboard, and place the brackets at the appropriate
location.
4. Thread the #6-32 X .50" panhead screw into the hanging
bracket, and tighten until the screw engages the aluminum
extrusion.
5. Insert the “S” hooks into the holes in the hanging brackets.
To adjust the viewing angle, insert each “S” hook into
another hole in the bracket.