User's Manual

Programming the Wallboard

22 Issue 1 November 1998

Programming the

Wallboard

You can program the following for the wallboard:

■ Running the Self-Test program

■ Clearing the memory

Use the wireless keyboard to program the wallboard.

NOTE:

These are the ONLY functions you can perform with the

wireless keyboard in a BCMS Vu environment. Disregard the

other programming procedures described in the manual that

is shipped with the wireless keyboard.

Running the Self-Test Program

You can run a self-test program via the wallboard. This program

checks to see if all columns of LEDs are functioning properly. With

the Self-Test program you also can easily clear the wallboard of all

information stored in memory.

Follow these steps to run the Self-Test program:

1. Press .

PROG TEST FILE A

appears on the display.

2. Press until

SET TIME AND DAY

SET TIME

appears.

3. Press until the

DAY

and

TIME

appear.

4. Using the keyboard, type “TEST.” Press “R” immediately

after TEST if you want to save the memory.

A number of diagnostic messages appear repeatedly until the test

is discontinued.

PROGRAM

BACK

ADV