User's Manual

Use two of the enclosure mounting holes as

a template (diagonally opposed), and mark

screw hole locations. If toggle bolts will be

used, use a drill to cut two, 1/2” diameter

holes in the ceiling.

Ceiling

Mounting Bolts

and Washers

Toggle bolts

(for sheet rock)

Enclosure

Mounting Holes

70V Surface-Mount Speaker

Speaker Installation

Issue 1, October 1999

54-2017-01 Printed in USA 9910

Specifications subject to change without notice.

PEC Code: 5330-235

COM Code: 408184075 Indoor

Model: LUSQIN70VS

PEC Code: 5330-240

COM Code: 408184083 Outdoor

Model: LUSQOT70VS

The first step is to determine where the speaker(s) will be mounted.Ensure power is not connected to speaker wires prior

to installation.

Follow all local safety and building codes and route 70-volt speaker wires to desired ceiling location. Pull approximately

12” of wire through opening in ceiling.

Pull speaker wire through top (large) opening of speaker enclosure. Using the supplied mounting hardware, secure the

enclosure to the ceiling.Note that two toggle bolt/screws (for sheet rock ceilings) and two wood screws (for securing to

solid wood/beams) have been included.Utilize the two washers (supplied) as well (see diagram below).

Page 1 of 2

PAGE 1
PEC Code: 5330-235 COM Code: 408184075 Model: LUSQIN70VS Indoor PEC Code: 5330-240 COM Code: 408184083 Model: LUSQOT70VS Outdoor 70V Surface-Mount Speaker Speaker Installation 1 The first step is to determine where the speaker(s) will be mounted. Ensure power is not connected to speaker wires prior to installation. Follow all local safety and building codes and route 70-volt speaker wires to desired ceiling location. Pull approximately 12” of wire through opening in ceiling.
PAGE 2
3 The next step is to attach the speaker wires to the appropriate taps (wires) located on the back of the speaker. The speaker will also work perfectly well with these connections reversed. However, it is important to be consistent in the wiring of the speakers in the system. If adjacent speakers have reversed wiring connections, they will tend to cancel each other’s bass response, diminishing the sound quality.