Configuration manual

12 WAN configuration
NN47928-501NN47928-501
4 Exit all levels of configuration mode:
end
End
Variable definitions
The following table describes the variables and values for configuring the uplink rate limit.
PPPoE WAN configuration
This section describes PPPoE WAN configuration.
Prerequisites for WAN configuration
• You must have SYSTEM - READ WRITE permission.
PPPoE WAN configuration procedures
The following task flow shows the sequence of procedures to perform to configure the PPPoE
WAN.
Variable Value
speed-in-bps
Specifies the uplink rate limit over the WAN interface (in bps).
The range is 100,000 to 100,000,000 bps.