Configuration manual

WAN configuration 13
Configuration — Command Line Interface
Figure 2 PPPoE WAN configuration procedures
Configuring the PPPoE WAN
Complete this procedure to configure the PPPoE WAN.
Prerequisites
• Access the box through an interface other than the WAN because this procedure closes down
the WAN.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Enter interface configuration mode on the WAN interface:
interface fastethernet 0/12
3 Disable the physical interface:
shutdown
4 Exit from interface configuration mode:
exit
The system is now in global configuration mode.
5 Enter interface configuration mode on the PPP interface:
interface ppp 1
6 Attach a PPP link to a physical ethernet:
layer fastethernet 0/12
7 Configure the PPP interface with the username and password: