Configuration manual

14 WAN configuration
NN47928-501NN47928-501
ppp username <username> password <password>
8 Enable the interface:
no shutdown
9 Exit from PPP interface configuration mode:
exit
The system is now in global configuration mode.
10 Enter interface configuration mode on the WAN interface:
interface fastethernet 0/9
11 Enable the interface:
no shutdown
12 Exit all levels of configuration mode:
end
End
Variable definitions
The following table describes the variables and values for configuring PPPoE WAN.
Configuring the uplink rate limit
Complete this procedure to configure the uplink rate limit. Only limit the uplink speed if
your WAN bandwidth is less than 100Base-T.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Set the uplink rate limit speed:
uplink rate limit <speed-in-bps>
3 Enable the uplink rate limit:
uplink rate limit enable
4 Exit all levels of configuration mode:
Variable Value
username
The PPPoE user name.
password
The PPPoE password.
hostname-of-BSG
The BSG host name.