Configuration manual

18 WAN configuration
NN47928-501NN47928-501
Configuring the uplink rate limit
Complete this procedure to enable the uplink rate limit. The rate limit value is based on the uplink
bandwidth of the ADSL service.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Set the uplink rate limit speed:
uplink rate limit <speed-in-bps>
3 Enable the uplink rate limit:
uplink rate limit enable
4 Exit all levels of configuration mode:
end
End
Variable definitions
The following table describes the variables and values for configuring the uplink rate limit.
Variable Value
speed-in-bps
Specifies the uplink rate limit over the WAN interface (in bps).
The range is 100,000 to 100,000,000 bps.