Configuration manual

SIP configuration 39
Configuration — Command Line Interface
Variable definitions
The following table describes the variables and values for configuring CAC settings.
Configuring FXS/FXO global information
Complete this procedure to configure FXS/FXO global information.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Enter VOIP configuration mode:
voip1000
3 Disable VOIP:
shutdown
4 Set the country code:
set country code <country-code>
5 Enable VOIP:
no shutdown
6 Exit from all configuration modes:
end
End
Variable Value
WAN-interface
Specifies the WAN interface. Valid values are:
Fa0/9 - for a direct ethernet connection
ppp1 - when using DSL
MaxCalls
Type the maximum simultaneous calls allowed on the WAN link.
The range is from 1 to 100.
The default value for BSG8ew is 50.
The default value for BSG12ew/aw/tw is 100.
Note: For BSG8ew, FXS2 (port 2) maintains connection to FXO during power
outage for emergency dialing. For BSG12ew/aw/tw, FXS1 (port 1) maintains
connection to FXO during power outage for emergency dialing.