Configuration manual

38 SIP configuration
NN47928-501NN47928-501
Configuring CAC
Complete this procedure to configure CAC settings.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
The system is now in global configuration mode.
2 Enter sip configuration mode:
sip
3 Enter bsg configuration mode:
bsg
4 Configure the maximum number of simultaneous SIP calls allowed:
set sipserver MaximumSimWANCallsAllowed <WAN-interface>
<MaxCalls>
5 Exit from bsg configuration mode
exit
6 Exit from sip configuration mode:
exit
7 Exit from all configuration modes:
end
End
port-number
The port number for the transport protocol. Values range from 1to 65535.
The default value is 5060
interval
The polling interval in seconds. Enter a number between 10 and 600.
The default value is 30 seconds.
retries
The number of polling retries. Values range from 1 to 10.
The default value is 2.
transport-protocol
Select the required transport protocol for SIP. Select one of the following
options:
•
udp - User Datagram Protocol
•
tcp - Transmission Control Protocol
• tls - Transport Layer Security
The default value is UDP.
Note: If the maximum number of simultaneous SIP calls across the WAN is
reached, the next SIP call attempt fails and the caller hears fast busy tone.
Variable Value