Configuration manual

SIP configuration 41
Configuration — Command Line Interface
set fxs line enable
13 Set phone number for FXS line 2:
set fxs channel-number <fxs-phone-number>
14 Set the display name:
set fxs display-name “John Doe”
15 Set the password for FXS line 2:
set fxs password <fxs-password>
16 Exit from interface configuration mode:
exit
17 Enter VOIP configuration mode:
voip1000
18 Enable VOIP:
no shutdown
19 Exit from all configuration modes:
end
End
Variable definitions
The following table describes the variables and values for configuring FXS information.
Configuring FXO
Complete this procedure to configure FXO information.
Variable Value
fxs-phone-number
The phone number assigned to the line. This is the number
that will be dialed to access this phone.
The maximum length is 31 digits.
fxs-password
The password to access the FXS line.
The maximum length is 31 digits.
Note: Use this procedure to configure the emergency number. You should
configure the emergency number (for example, 911) before you use the SIP
server. This ensures that an emergency call originating on your system reaches its
destination if the SIP server becomes unavailable.