Configuration manual

48 VPN configuration
NN47928-501NN47928-501
Variable definitions
The following table describes the variables and values for configuring the user database.
Configuring the address pool
Complete this procedure to configure the address pool.
Prerequisites
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Configure the address pool for incoming VPN connections:
ip ra-vpn pool <poolname> <start_ip-end_ip>
3 Exit from all configuration modes:
end
End
Variable definitions
The following table describes the variables and values for configuring the VPN address pool.
Variable Value
username
The user name.
The range is 1 to 31 characters.
password
The password for the user.
The range is 1 to 31 characters.
Note: The address pool cannot be in the same subnet as DHCP addresses.
Variable Value
poolname
The name of the address pool. Addresses within the pool are allocated to
remote users when they make VPN connection requests.
start_ip
The first IP address of the pool.
end_ip The last IP address of the pool.