Configuration manual

VPN configuration 55
Configuration — Command Line Interface
Enabling VPN (branch office)
Complete this procedure to enable VPN.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Enable VPN:
set vpn enable
3 Exit from all configuration modes:
end
End
exch-mode
The exchange mode. Valid values are:
• Main - for the highest level of Security.
• Aggressive - for speed
lifetime-units
The life time unit. Valid values are secs | mins | hrs
lifetime-value
The life time value.
The range is 5 minutes to 8 hours.
source-IP
The Source IP address of the outbound traffic.
source-subnet-mask
The Network mask of the outbound traffic.
dest-IP
The Destination IP address of the outbound traffic.
dest-subnet-mask
The Destination mask of the outbound traffic.
WAN-interface-type
The valid values are:
ppp - use for DSL
fastethernet - use for direct connection to ethernet or cable modem
WAN-interface-id
The valid values are:
1 - use for DSL
0/9 - user for direct connection to ethernet or cable modem
Variable Value