Configuration manual

QoS configuration 59
Configuration — Command Line Interface
Configuring the uplink rate limit
Complete this procedure to configure the uplink rate limit. This procedure is optional for
the Ethernet WAN.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Set the uplink rate limit speed:
uplink rate limit <speed-in-bps>
3 Enable the uplink rate limit:
uplink rate limit enable
4 Exit all levels of configuration mode:
end
End
Variable definitions
The following table describes the variables and values for configuring the uplink rate limit.
Configuring a policy map
Complete this procedure to configure a policy map. A policy map defines the committed and peak
bandwidth for a type of traffic.
Using TRTCM, the BSG meters the IP packet stream and marks the packets based on Peak
Information Rate (PIR) and Committed Information Rate (CIR), and their associated burst sizes
(CBS and PBS). TRTCM marks the packet red if it exceeds PIR, yellow if it exceeds CIR, and
green if it does not exceed CIR.
Procedure steps
Step Action
1 Enter global configuration mode:
configure terminal
2 Create the policy map and assign rate values:
Variable Value
speed-in-bps
Specifies the uplink rate limit over the WAN interface (in bps).
The range is 100,000 to 100,000,000 bps.