User Guide
284 BSGX4e Business Gateway User Guide
NN47928-102 Release 01.01
Chan LocalNumber CodecType LocalConn RtcpTx RtpTx
Port RemoteNumber CodecState RemoteConn RtcpRx RtpRx
----------------------------------------------------------------------
5 1001 G711a 172.29.3.11:13008 0 0
0 2720 STARTED 172.29.11.120:16384 0 0
The LocalConn and RemoteConn fields report the local and remote IP
addresses and port numbers used by RTP for the connection.
The CodecType and CodecState fields report the status of the media stream.
In this example, the connection is started and uses the CODEC G.711 a-law.
The RtcpTx and RtcpRx fields report the number of RTCP packets transmitted
and received. The RtpTx and RtpRx fields report the number of RTP packets
transmitted and received.
Numbering Plan for the Gateway
When an analog device, such as a phone, is connected to the FxS port, a numbering
plan can be necessary to make full use of the features of the device. The SIP
integrated gateway uses a numbering plan to interpret any string entered from the
analog device.
The plan is a series of entries, each which defines how a specific string is to be
interpreted. When the gateway receives a string from the analog device, it
compares the string to the entries in the numbering plan and translates the string as
needed before it is sent to the server.
For service codes, the digits dialed are sent without modification.
Note: Every service request entry must end with a hash character [#] to activate
the service. For example, if the Do Not Disturb code is set to *78, then an
entry to activate Do Not Disturb for a phone is *78#.
For phone numbers, the string of digits can be translated as follows:
n A number of digits can be stripped from the beginning of the number.
n A string of digits can be prepended to the beginning of the number.
NOTE: Before you configure the numbering plan, you must configure the SIP
gateway. See “SIP Gateway Configuration” (page 280).
Numbering Plan Command
To define an entry in the numbering plan, enter the following command:
> config voice np
Table 88 describes the parameters for config voice np.
Table 88. SIP Numbering Plan Parameters
Parameter Description
[number] String translated by the entry.