User's Manual

120 Chapter 3 Security
212160-B
Using MAC address security
You configure the BaySecure* application using MAC addresses with the
following commands:
• “show mac-security command,” next
• “show mac-security mac-da-filter command” on page 121
• “mac-security command” on page 122
• “mac-security mac-address-table address command” on page 123
• “mac-security security-list command” on page 124
• “no mac-security command” on page 125
• “no mac-security mac-address-table command” on page 125
• “no mac-security security-list command” on page 126
• “mac-security command for specific ports” on page 126
• “mac-security mac-da-filter command” on page 127
show mac-security command
The show mac-security command displays configuration information for the
BaySecure application. The syntax for the
show mac-security command is:
show mac-security {config|mac-address-table [address
<macaddr>]|port|security-lists}
The show mac-security command is in the privExec command mode.
Table 60 no ipmgr command for source IP addresses parameters and variables
Parameters and variables Description
source-ip [<1-10>] When you specify an option, it sets the IP address and
mask for the specified entry to 255.255.255.255 and
255.255.255.255.
When you omit the optional parameter, it resets the list to
factory defaults.