User's Manual

Chapter 4 Spanning Tree, MLT, and Port-Mirroring 147
Reference for the Business Policy Switch 2000 Command Line Interface
The default spanning-tree command by port is in the config-if command
mode.
Table 82 describes the parameters and variables for the
default
spanning-tree command by port.
no spanning-tree command by port
The no spanning-tree command by port disables spanning tree for a port in a
specific spanning tree group. The syntax for the
no spanning-tree command
by port is:
no spanning-tree [port <portlist>] [stp <1-8>]
The no spanning-tree command by port is in the config-if command mode.
Table 82 default spanning-tree command by port parameters and variables
Parameters and
variables
Description
port <portlist> Enables spanning tree for the specified port or ports; enter port
or ports you want set to factory spanning tree default values.
Note: If you omit this parameter, the system uses the port
number you specified when you issued the interface
command.
stp <1-8> Specifies the spanning tree group you want to set to factory
default value; enter the STG ID. This command places the port
into the default STG.
Default value for STG is 1.
learning Sets the spanning tree learning mode to factory default value.
Default value for learning is normal mode.
cost Sets the path cost to factory default value.
Default value for path cost depends on the type of port.
priority Sets the priority to factory default value.
Default value for the priority is 0x8000.