User's Manual

174 Chapter 6 Policy-enabled networks and QoS
212160-B
Displaying QoS parameters
You can display QoS parameters using the CLI. show qos command
The
show qos command displays the current QoS policy configuration The
syntax for the
show qos command is:
show qos [interface-groups|interface-assignments|
if-assign-list|egressmap|ingressmap|
ip-filters|ip-filter-sets|
l2-filters|l2-filter-sets|
actions|meters|shapers|policies|
queue-sets|queue-set-assignments|
agent|statistics]
The show qos command is in the privExec command mode.
Table 104 describes the parameters and variables for the
show qos command.
Table 104 show qos command parameters and variables
Parameters and variables Description
interface-groups Displays configured interface groups.
interface-assignments Displays interface-to-interface group assignments.
if-assign-list Displays interface-to-interface group assignments.
egressmap Displays DSCP-to-802.1p priority and loss-sensitivity mapping.
ingressmap Displays 802.1p priority-to-DSCP mapping.
ip-filters Displays defined IP filters.
ip-filter-sets Displays defined IP filter sets.
l2-filters Displays defined Layer 2 filters.
l2-filter-sets Displays defined Layer 2 filter sets.
actions Displays defined QoS action entries.
meters Displays defined traffic metering entries.
shapers Displays defined traffic shaping entries.
policies Displays configured QoS policies.
queue-sets Displays current queue set information.
queue-set-assignments Displays 802.1p priority-to-queue assignments by queue set.