User's Manual

Chapter 6 Policy-enabled networks and QoS 205
Reference for the Business Policy Switch 2000 Command Line Interface
Configuring QoS meters
Using the CLI, you set meters. If you want to meter, or police, the traffic,
configure the committed rate, burst rate, and burst duration. If you are not
metering data, skip this page.
qos meter command
The qos meter command creates or deletes a QoS meter. The syntax for the qos
meter
command is:
qos meter <metid> {create [name <metname>] committed-rate
<rate> max-burst-rate <burstrate> [max-burst-duration
<burstdur>]|delete}
update-1p Specifies whether 802.1p priority value should be updated or left
unchanged; unchanged equals ignore:
• ieee1p—enter the value you want; range is 0 to 7
• default—allows the value to be derived based on assignment of
other action parameters
• use-egress-map—uses the egress map to assign value
Default is default.
set-drop-prec
{loss-sensitive|not-
loss-sensitive|
default|use-egress
-map}
Enter the loss-sensitivity value you want:
• loss-sensitive
• not-loss-sensitive
• default
• use-egress-map
Default is use default.
Note: Certain options may be restricted based on the policy associated
with the specific action.
You cannot delete an action that is referenced in an installed policy.
Table 120 qos action command parameters and variables (continued)
Parameters and
variables
Description