User's Manual

30 Chapter 1 CLI Basics
212160-B
The Interface Configuration commands allow you to configure parameters for
each port, such as speed, duplex mode, and rate-limiting. The Interface
Configuration mode is also referred to as config-if mode.
Figure 1 provides an illustration of the hierarchy of BPS 2000 CLI command
modes.
Figure 1 CLI command mode hierarchy
You see a specific value for each command mode at the prompt line, and you use
specific commands to enter or exit each command mode (Table 1). Additionally,
you can only enter command modes from specific modes and only exit to specific
command modes.
10194EA
User Exec
(exec)
Privileged EXEC
(privExec)
Global Configuration
(config)
Interface Configuration
(config-if)