User's Manual

58 Chapter 2 General CLI commands
212160-B
Setting the terminal
You can view the terminal settings, set them to default settings, or customize the
terminal settings.This sections covers:
• “show terminal command,” next
• “default terminal command” on page 58
• “terminal command” on page 59
show terminal command
The show terminal command displays the current serial port information,
which includes connection speed, as well as the terminal width and length in
number of characters. The syntax for the
show terminal command is:
show terminal
The show terminal command is in the exec command mode.
The
show terminal command has no parameters or variables.
Figure 11 displays the output from the
show terminal command.
Figure 11 show terminal command output
default terminal command
The default terminal command configures default settings for the terminal.
These settings are transmit and receive speeds, terminal length, and terminal
width. The syntax for the
default terminal command is:
BPS2000#show terminal
Terminal speed: 9600
Terminal width: 79
Terminal length: 23
BPS2000#