User's Manual

68 Chapter 2 Configuring and graphing the switch
209322-B
3 Click the Trap Receivers tab.
The Trap Receivers tab opens (Figure 27).
Figure 27 Edit Chassis dialog box — Trap Receivers tab
Table 22 describes the Trap Receivers tab items.
Editing network traps
To edit the network traps table:
1 In the Trap Receivers tab (Figure 27), click Insert.
The Chassis, Insert Trap Receive dialog box opens (Figure 28).
Table 22 Edit Chassis dialog box — Trap Receivers tab items
Item Description
NetAddr The address (or DNS hostname) for the trap receiver.
Community Community string used for trap messages to this trap receiver.
Status This object is used to create and delete rows in the table and control
them if they are used. The values that can be written are:
• valid — makes an existing row valid - can only be written to change
the value from the ignore values
• ignore —Note: do not use this entry to send traps to at this time
• delete—deletes the row
• create—creates a new row. This is the only value that can be used
to create a row in the table. If the row exists, then a SET with value
of create shows error 'badValue'. Deleted rows are removed
immediately. The following values can be returned on reads:
other — some other case; valid—the row exists and is valid;
ignore — Note: do not use this entry to send traps to at this time.