Configuration manual

Chapter 9 Network Address Translation (NAT) 109
Nortel Business Secure Router 222 Configuration — Advanced
Figure 39 Menu 11.1.2: Applying NAT to the Remote Node
Table 27 describes the fields in Figure 39.
Menu 11.1.2 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= Full Feature
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Table 27 Applying NAT in Menus 4 & 11.1.2
Field Description Options
Network
Address
Translation
When you select this option the SMT uses Address
Mapping Set 1 (menu 15.1 - “Address Mapping Sets” on
page 110 for further discussion). Choose Full Feature if
you have multiple public WAN IP addresses for your
Business Secure Router.
When you select Full Feature you must configure at least
one address mapping set!
Full Feature
NAT is disabled when you select this option. None
When you select this option the SMT uses Address
Mapping Set 255 (menu 15.1 - “Address Mapping Sets” on
page 110). Choose SUA Only if you have just one public
WAN IP address for your Business Secure Router.
SUA Only