Configuration manual

278 Appendix H Command Interpreter
NN47922-501
udp
Sends the trace packets to another
system using UDP.
udp switch [on|off]
Enables or disables the sending of the
trace packets to another system using
UDP or displays the current setting.
udp addr <addr>
Sets the target IP address for sending
trace packets using UDP.
udp port <port>
Sets the UDP port (should match that
of the target IP address) for sending
trace packets using UDP.
parse [[start_idx], end_idx]
Displays detailed packet details of the
packet range specified.
brief
Displays a brief listing of packet
contents.
version
Displays the RAS code and driver
versions.
view <filename>
Displays the specified text file.
wdog
switch [on|off]
Turns the watchdog firmware
protection feature on or off.
cnt [value]
Sets (0-34 463) or displays the current
watchdog count (in 1.6 sec units).
romreset
Restores the factory default
configuration file.
server
Use these commands to configure
remote server management.
access
<telnet|ftp|web|icmp|snmp|
dns> <value>
Sets the server access type.
load
Loads server information.
disp
Displays server information.
port <telnet|ftp|web|snmp>
<port>
Sets the server port.
save
Saves server information.
secureip <telnet|ftp|
web|icmp|snmp|dns> <ip>
Sets server secure IP address.
Table 69 Sys commands
Command Description